Processed Long Pips (10)

Processed Long Pips
by Taufik 20 years ago

Re: Processed Long Pips
by Tim 20 years ago

Re: Processed Long Pips
by cole ely 20 years ago

Re: Processed Long Pips
by Old Fogey 20 years ago

Re: Processed Long Pips
by Taufik 20 years ago

Re: Processed Long Pips
by cole 20 years ago

Re: Processed Long Pips
by Taufik 20 years ago

Re: Processed Long Pips
by Yves 20 years ago

Re: Processed Long Pips
by Taufik 20 years ago

Re: Processed Long Pips
by Yves 20 years ago

Re: Processed Long Pips
by Taufik 20 years ago

Re: Processed Long Pips
by taufik kesuma 20 years ago

Re: Processed Long Pips
by Taufik 20 years ago

The following message (subject: Re: Processed Long Pips) was posted by Yves, on 12/5/2004 2:00:55 PM:

Rule 2.04.03:
A side of the blade used for striking the ball shall be covered with either ordinary pimpled rubber, with pimples outwards having a total thickness including adhesive of not more than 2mm, or sandwich rubber, with pimples inwards or outwards, having a total thickness including adhesive of not more than 4mm.

Consequently, your rubber does not violate this rule.

On the other hand, are you sure about the 1.1-ratio?

Report Abuse