Return to Topic Index |
Most average sizes od blade head (5)
Most average sizes od blade head
by ZoranV 18 years ago
by ZoranV 18 years ago
Re: Most average sizes od blade head
by VictorK 18 years ago
by VictorK 18 years ago
Re: Most average sizes od blade head
by ZoranV 18 years ago
by ZoranV 18 years ago
Re: Most average sizes od blade head
by Leo 18 years ago
by Leo 18 years ago
Re: Most average sizes od blade head
by VictorK 18 years ago
by VictorK 18 years ago
Re: Most average sizes od blade head
by Leo 18 years ago
by Leo 18 years ago
Re: Most average sizes od blade head
by ZoranV 18 years ago
by ZoranV 18 years ago
Re: Most average sizes od blade head
by BKTT 18 years ago
by BKTT 18 years ago
Re: Most average sizes od blade head
by ZoranV 18 years ago
by ZoranV 18 years ago
The following message (subject: Re: Most average sizes od blade head) was posted by VictorK, on 3/20/2006 2:12:26 PM:
Unfortunately, there's no perfect solution to Zoran's problem. I personally don't mind if my rubber is slightly bigger than blade, but I don't like if they are smaller (especially if they are too narrow). Therefore, I'd be in favor of cutting slightly bigger rubbers, e.g. 158 by 152. I also noticed that some Donic and Tibhar blades are quite small, while Bty blades (at least the once I've played with) are typically a bit bigger than average. |