trans





Return to Topic Index

Most average sizes od blade head (6)

 Most average sizes od blade head
by ZoranV 13 years ago
 Re: Most average sizes od blade head
by VictorK 13 years ago
 Re: Most average sizes od blade head
by ZoranV 13 years ago
 Re: Most average sizes od blade head
by VictorK 13 years ago
Re: Most average sizes od blade head
by Leo 13 years ago
 Re: Most average sizes od blade head
by ZoranV 13 years ago
 Re: Most average sizes od blade head
by ZoranV 13 years ago


The following message (subject: Re: Most average sizes od blade head) was posted by Leo, on 3/20/2006 2:54:40 PM:
Yes, it's bad if the rubber is too narrow, a little bit short is OK, though, as you can leave a gap close to the handle. Now, by using speed glue you can make a rubber a little bit bigger, especially on sides by stretching it out on the blade, using, say some kind of roller for this.
Report Abuse
Search Forum